#TRYHACKME BURP SUITE REPEATER ANSWERS HOW TO#
#TRYHACKME BURP SUITE REPEATER ANSWERS MANUAL#
#TRYHACKME BURP SUITE REPEATER ANSWERS SERIES#

When we send requests to Repeater from other parts of Burp Suite, this will be filled in automatically.ĭon’t worry if this doesn’t make too much sense just now - you will get plenty of chances to learn what it does first hand in the upcoming tasks! Answer the questions belowįamiliarise yourself with the Repeater interface. Quite simply, this is the IP address or domain to which we are sending requests. Finally, above the Inspector we have our target.At the right-hand side of the window, we have the Inspector, which allows us to break requests apart to analyse and edit them in a slightly more intuitive way than with the raw editor.By default, this is usually side-by-side (horizontal layout, as in the screenshot) however, we can also choose to put them above/below each other (vertical layout) or in separate tabs (combined view). Above the request/response section, on the right-hand side, is a set of options allowing us to change the layout for the request and response views.The response will show up in the Response view. We edit the request in the Request view then press send. Still on the left-hand side of the tab, but taking up most of the window, we have the request and response view.These allow us to send a request, cancel a hanging request, and go forwards/backwards in the request history.

Directly underneath the request list, we have the controls for the current request.

We can have many different requests going through Repeater: each time we send a new request to Repeater, it will appear up here.

At the very top left of the tab, we have a list of Repeater requests.

The Repeater interface can be split into six main sections - an annotated diagram can be found below the following bullet points:

#TRYHACKME BURP SUITE REPEATER ANSWERS MANUAL#

This ability to edit and resend the same request multiple times makes Repeater ideal for any kind of manual poking around at an endpoint, providing us with a nice Graphical User Interface (GUI) for writing the request payload and numerous views (including a rendering engine for a graphical view) of the response so that we can see the results of our handiwork in action. Alternatively, we could craft requests by hand, much as we would from the CLI ( Command Line Interface), using a tool such as cURL to build and send requests. In layman’s terms, it means we can take a request captured in the Proxy, edit it, and send the same request repeatedly as many times as we wish.

In short: Burp Suite Repeater allows us to craft and/or relay intercepted requests to a target at will. Task 2 Repeater What is Repeater?īefore we start using Repeater, it will help to have a good idea of what it does. Note: If you are not using the AttackBox and want to connect to this machine without the VPN, you can do so using this link once the machine has fully loaded and an IP address is displayed. Answer the questions belowĭeploy the machine (and the AttackBox if you are not using your own attack VM), and let’s get started! If you have not used Burp Suite before and have not completed the Burp Basics room, you may wish to do so now before continuing, as this room builds on the foundations covered there.

#TRYHACKME BURP SUITE REPEATER ANSWERS SERIES#

Finally, we will encounter a series of examples, including a real-world, extra-mile exercise which we will use to consolidate the more theoretical aspects of the room.

#TRYHACKME BURP SUITE REPEATER ANSWERS HOW TO#

We will be covering how to use Repeater to manipulate and arbitrarily resend captured requests, as well as looking at some of the niftier options available in this awesome tool. Having covered the basics of using Burp Suite, this room will dive into one of the more powerful aspects of the framework, namely: the Burp Suite Repeater module. Learn how to use Repeater to duplicate requests in Burp Suite Task 1 Introduction Outline

Tryhackme burp suite repeater answers